Table of Contents
Advertisement
AConfigure and Environment
Configure Board Information Block
CNFG [;[I][M]]
This command is used to display and configure the board information
block. This block is resident within the Non-Volatile RAM (NVRAM).
Refer to the MVME162LX Embedded Controller Programmer's Reference
Guide for the actual location. The information block contains various
elements detailing specific operation parameters of the hardware. The
MVME162LX Embedded Controller Programmer's Reference Guide
describes the elements within the board information block, and lists the
size and logical offset of each element. The CNFG command does not
describe the elements and their use. The board information block contents
are checksummed for validation purposes. This checksum is the last
element of the block.
Although the factory fills all fields except the Industry Pack fields, only
these fields MUST contain correct information:
The board structure for the MVME162LX is as follows:
162-Bug>
Board (PWA) Serial Number
Board Identifier
Artwork (PWA) Identifier
MPU Clock Speed
Ethernet Address
Local SCSI Identifier
Parity Memory Mezzanine Artwork (PWA) Identifier
Parity Memory Mezzanine (PWA) Serial Number
Static Memory Mezzanine Artwork (PWA) Identifier
Static Memory Mezzanine (PWA) Serial Number
ECC Memory Mezzanine #1 Artwork (PWA) Identifier
ECC Memory Mezzanine #1 (PWA) Serial Number
MPU clock speed
Ethernet address
Local SCSI identifier
cnfg
Commands
= "
= "
= "
= "
= 08003E200000
= "
= "
= "
= "
= "
= "
= "
A
"
"
"
"
"
"
"
"
"
"
"
A-1
Advertisement
Table of Contents
