Table of Contents
Advertisement
Hardware Preparation and Installation
Installation Instructions
2
IP Installation on the MVME162LX
2-12
The following sections describe the installation of IndustryPacks (IPs) on
the MVME162LX Embedded Controller and the installation of the
controller in a VME chassis, and discuss system considerations relevant to
the installation. Ensure that EPROM devices are installed as needed.
Ensure that all header jumpers are configured as desired.
Up to two IP modules may be installed on the controller. Install the IPs on
the controller as follows:
Each IP has two 50-pin connectors that plug into two corresponding
50-pin connectors on the controller: J5/J6, J7/J8. See Figure 2-1 for
the connector locations.
– Orient the IP(s) so that the tapered connector shells mate
properly. Plug IP_a into connectors J5 and J6; plug IP_b into J7
and J8. If a double-sized IP is used, plug IP_ab into J5, J6, J7,
and J8.
Two additional 50-pin connectors (J3 and J4) are provided behind
the controller's front panel for external cabling connections to the IP
modules. There is a one-to-one correspondence between the signals
on the cabling connectors and the signals on the associated IP
connectors (J4 has the same IP_a signals as J5; J3 has the same IP_b
signals as J7).
– Connect user-supplied 50-pin cables to J3 and J4 as needed.
Because of the varying requirements for each different kind of
IP, Motorola does not supply these cables.
– Bring the IP cables out the narrow slot in the controller's front
panel and attach them to the appropriate external equipment,
depending on the nature of the particular IP(s).
Computer Group Literature Center Web Site
Advertisement
Table of Contents
