Installation Instructions; Table 1-5. Mcecc Dram Size Settings - Motorola MVME162P-344 Series Installation And Use Manual

Hardware Preparation and Installation
1

Installation Instructions

1-22

Table 1-5. MCECC DRAM Size Settings

S6 S6
Segment 1 Segment 2
ON ON
ON ON
ON OFF
ON OFF
OFF ON
Note For the MCECC memory model to be enabled, the MC2
emulation must be disabled. You disable the MC2 memory
model by setting the MC2 DRAM size select switch (S3) to
110 (Off/Off/On). Refer to
details.
The factory default setting for S6 is 16MB (On/Off/On). If
you modify the switch settings, you will need to execute
env;d <CR> so that the firmware recognizes the new
memory defaults.
This section covers:
Installation of IndustryPacks (IPs) on the MVME162P4
Installation of the MVME162P4 in a VME chassis
System considerations relevant to the installation. Ensure that an
EPROM device is installed as needed. Before installing
IndustryPacks, ensure that the serial ports and all header jumpers
and configuration switches are set as appropriate.
S6 MCECC
Segment 3 DRAM Size
ON 4MB
OFF 8MB
ON 16MB
OFF 32MB
ON 64MB
MC2 DRAM Size (S3)
Computer Group Literature Center Web Site
for further