GE AKTAprime plus Operating Instructions Manual page 37

Preparing the fraction collector
1 Fill the fraction collector rack with, for example, 18 mm tubes (minimum 40 pcs.).
2 Adjust the height of the delivery arm using the lock knob (1) so that the bottom of
3 If necessary, adjust the length of the tubing exposed according to the sequence
ÄKTAprime plus Operating Instructions 28-9597-89 AB
No. Description
1 Tubing from injection valve
2 1/16" male connector
Note:
Other unions and connectors might be required for other columns.
the tube sensor (2) is about 5 mm below the top of the tubes. The tubes should always
be below the horizontal mark on the tube sensor.
1
5 mm
shown below (the hole in the delivery arm used in step 3 and 4 is only used for ad-
justing the tubing length).
1.
2.
No. Description
3 HisTrap column
4 UV cell
2
3.
4.
4 Operation
4.3 Preparations before start
5.
37