Disassembly; Manual Brush Cleaning - Taylor C723 Operator's Manual

Disassembly

MAKE SURE THE POWER SWITCH IS IN
THE "OFF" POSITION! Failure to follow this
instruction may result in severe personal injury from
hazardous moving parts.
Step 1
From the freezing cylinder, remove the handscrews,
freezer door, the beater and scraper blades, and the
drive shaft.
Step 2
Remove the scraper blades from the beater
assembly.
Step 3
Remove the drive shaft seal from the drive shaft.
Step 4
Remove the freezer door gasket, front bearing, pivot
pin, draw handle, draw valve, prime plugs and
design caps. Remove the three o-rings from the
draw valve.
Step 5
Repeat these steps on the other side of the
machine.
Step 6
Remove the front drip tray, splash shield, and drip
pan. Take them to the sink for cleaning.
Figure 69
Note: If the drip pan is filled with an excessive
amount of mix, it is an indication that the drive shaft
seal(s), or o-ring(s) should be replaced or properly
lubricated.
151124
Operating Procedures

Manual Brush Cleaning

These procedures must be completed according to
the frequency specified by your Federal, State, or
local regulatory agencies. Please consult your
governing Food Code to determine the maximum
number of days allowed between brush clean
cycles.
Use the recommended cleaning procedure outlined
in the manual or an alternate procedure used in
conjunction with a cleaning/sanitizing system that
has been certified by NSF.
ALWAYS FOLLOW LOCAL HEALTH CODES.
Step 1
Prepare an approved 100 PPM cleaning solution
(examples: 2-1/2 gal. [9.5 liters] of Kay-5R
or 2 gal. [7.6 liters] of Stera-SheenR). USE WARM
WATER AND FOLLOW THE MANUFACTURER'S
SPECIFICATIONS. Make sure all brushes provided
with the freezer are available for brush cleaning.
Step 2
Thoroughly brush clean all disassembled parts in the
cleaning solution, making sure all lubricant and mix
film is removed. Be sure to brush all surfaces and
holes, especially the holes in the freezer door.
Step 3
Rinse all parts with clean, warm water. Place the
parts on a clean, dry surface to air dry overnight.
36
Model C723