Taylor C723 Operator's Manual page 22

Wash Symbol
The WASH symbol will illuminate when it is
touched. This indicates beater motor operation. The
STANDBY or AUTO modes must be cancelled first
to activate the WASH mode.
Note: An indicating light and an audible tone will
sound whenever a mode of operation has been
selected. To cancel any function, touch the key
again. The light and the mode of operation will shut
off.
Standby Symbol
During long "No Sale" periods, the unit can be
placed in the Standby mode. This maintains product
temperatures below 40°F (4.4°C) in both the hopper
and the freezing cylinder and helps prevent
overbeating and product breakdown.
To activate Standby, select the STANDBY key or
enter the access code for the Manager Menu and
select the Standby Mode option (see pages 21 and
24). The STANDBY symbol
indicating the Standby feature has been activated.
Using clean and sanitized hands, remove the air
orifice. Lubricate the o-rings located on the end of
the feed tube without the mix delivery hole. Place
that end of the tube into the mix inlet hole.
Feed Tube Position During Standby Operation:
Figure 8
IMPORTANT: Make sure the level of mix in the
hopper is below the mix delivery hole in the feed
tube. Failure to follow this instruction may result in
lower product quality when normal operation is
resumed.
130703
Important: To the Operator
will illuminate,
18
To resume normal operation, press the AUTO
symbol . When the unit cycles off, the product in
the freezing cylinder will be at serving viscosity.
Using clean and sanitized hands, turn the feed tube
over and place the end of the tube with the mix
delivery hole into the mix inlet hole. Install the air
orifice.
Feed Tube Position During Normal Operation:
Figure 9
Reset Mechanism
The reset buttons are located in the left side panel of
the machine. They protect the beater motors from
an overload condition. Should an overload occur, the
reset mechanism will trip. To properly reset the
freezer, place the power switch in the OFF position.
Press the reset button firmly. Turn the power switch
to the ON position. Touch the WASH symbol
observe the freezer's performance.
WARNING: Do not use metal objects to
press the reset button. Failure to comply may
result in severe personal injury or death.
If the beater motor is turning properly, touch the
WASH symbol to cancel the cycle. Touch the
AUTO symbol to resume normal operation. If the
freezer shuts down again, contact your authorized
service technician.
and
Model C723