Taylor C723 Operator's Manual page 45

PROBLEM
4. The mix in the hopper is
too warm.
5. The mix in the hopper is
too cold.
6. Mix Low and Mix Out
probes are not
functioning.
7. Product is collecting on
top of the freezer door.
8. Excessive mix leakage
from the bottom of door
spout.
9. Excessive mix leakage
into the drip pan.
Model C723
PROBABLE CAUSE
a. Hopper cover is not in
position.
b. The hopper temperature is
out of adjustment.
c. Agitator is not installed
(factory-equipped agitator
units, only).
a. The hopper temperature is
out of adjustment.
a. Milkstone build-up in the
hopper.
a. The top o-ring on draw
valve is improperly
lubricated or is worn.
a. Bottom o-ring on draw
valve is improperly
lubricated is or worn.
a. The seal on drive shaft is
improperly lubricated or
worn.
b. The seal is installed
inside-out on the drive
shaft.
c. Inadequate lubrication of
the drive shaft.
d. The drive shaft and beater
assembly work forward.
e. Worn rear shell bearing.
f. Gear box out of alignment.
41
REMEDY
a. Clean and sanitize hopper
cover and place in
position.
b. Call an authorized service
technician.
c. Clean and sanitize the
agitator and install.
a. Call an authorized service
technician.
a. Clean hoppers thoroughly.
a. Lubricate properly or
replace the o-ring.
a. Lubricate properly or
replace the o-ring.
a. Lubricate properly or
replace the seal.
b. Install correctly.
c. Lubricate properly.
d. Call an authorized service
technician.
e. Call an authorized service
technician.
f. Call an authorized service
technician.
Important: Operator Checklist
PAGE
REF.
34
- - -
33
- - -
36
30
30
27
27
27
- - -
- - -
- - -