Cleaning; Disassembly - Taylor C300 Operator's Manual

3. Allow the rinse water to flow into the cylinder until it is
approximately 2/3 full. With a pail under the door
spout, open the draw valve and drain the rinse water.
Repeat this step until the rinse water being drawn is
clear.
4. Repeat steps 2 and 3 for the right side.
RINSE
RIGHT SIDE
< - - - > -
5. When draining is complete, press the OFF (<- -) key.

Cleaning

1. Prepare 1 gal. (7.6 L) of an approved cleaning
solution (examples: Stera-Sheen
warm water and follow the manufacturer's
specifications.
Important! Make sure the cleaner is completely
dissolved.
2. Place the syrup line with the old syrup connector into
the pail of cleaner
3. To place the left freezing cylinder in the Sanitize
mode, press the MENU (SEL) key. Move the cursor
by pressing the AUTO (- ->) key until the third line
indicates RINSE / SANITIZE. Press the MENU (SEL)
key. Move the cursor under the word SANITIZE.
RINSE / SANITIZE
RINSE SANITIZE
- - - - -
< - - - > -
Pressing the MENU (SEL) key will give you the
option to sanitize the left cylinder. Move the cursor
under the word YES. Pressing the MENU (SEL) key
at this time will start the flow of cleaner/sanitizer
through the syrup system into the freezing cylinder.
SANITIZE
LEFT SIDE
< - - - > -
4. Repeat steps 1 through 3 for the right side freezing
cylinder.
Operating Procedures
5. Open the prime plugs. Allow each cylinder to fill
6. Continue filling the freezing cylinders with sanitizing
7. Press the BEATER (- - -) key to agitate the solution in
YES NO
- - -
S E L
® ®
or Kay-5 ). Use
8. With a pail beneath the door spouts, open the draw

Disassembly

EXIT
the OFF position to eliminate the chance of moving parts.
S E L
Failure to follow this instruction may result in severe
personal injury from hazardous moving parts.
1. Make sure the control switch is in the OFF position.
2. Open the prime plug. Leave the prime plug open
YES NO
- - -
S E L
Model C300
OPERATING PROCEDURES
approximately 2/3 full. Close each prime plug.
solution until the solution purges out of each vent,
and begins draining into the front drip tray. 
The relief valves are located at the top of each
mix tank. Press the OFF (<- - ) key
each freezing cylinder for 5 minutes.
Figure 6-40
valves and drain all the solution from the freezing
cylinders. Press the OFF (<- -) key and close the
draw valves.
WARNING! Make sure the control switch is in
Open the draw valves to make sure all pressure has
been relieved.
when removing the freezer door to ensure that all
pressure is relieved from the freezing cylinder.
13040
6
6-11