Taylor C723 Operator's Manual page 46

PROBLEM
10. The drive shaft is stuck in
the drive coupling.
11. The freezing cylinder
walls are scored.
12. The product makes a
popping sound when
drawn.
13. No control panel functions
with power switch ON.
Important: Operator Checklist
PROBABLE CAUSE
a. Mix and lubricant collected
in drive coupling.
b. Rounded corners of drive
shaft, drive coupling, or
both.
c. Gear box is out of
alignment.
a. Missing or worn front
bearing.
b. Broken freezer door baffle
rod.
c. Beater assembly is bent.
d. Gear box is out of
alignment.
a. Draw rate is set too fast.
b. Freezing cylinder not
primed correctly.
a. Machine is unplugged.
b. Circuit breaker OFF or
blown fuse.
42
REMEDY
a. Brush clean the rear shell
bearing area regularly.
b. Call an authorized service
technician.
c. Call an authorized service
technician.
a. Install or replace the front
bearing.
b. Replace freezer door.
c. Replace beater assembly.
d. Call an authorized service
technician.
a. Adjust draw rate of 5 to 7
1/2 oz. (142 g. to 213 g.)
of product by weight in 10
seconds.
b. Drain the freezing cylinder
and reprime the machine.
a. Plug into wall receptacle.
b. Turn the breaker ON or
replace the fuse.
PAGE
REF.
37
- - -
- - -
28
29
29
- - -
31
34
- - -
- - -
Model C723