Taylor C723 Operator's Manual page 37

Step 4
Prepare another pail of approved 100 PPM
sanitizing solution (examples: 2-1/2 gal. [9.5 liters] of
Kay-5R or 2 gal. [7.6 liters] of Stera-SheenR).
USE WARM WATER AND FOLLOW THE
MANUFACTURER'S SPECIFICATIONS.
Step 5
Pour the sanitizing solution into the mix hopper.
Step 6
Brush the exposed sides of the hopper.
Step 7
Place the power switch in the ON position.
Step 8
Touch the WASH symbol
sanitizing solution in the freezing cylinder to agitate.
A five minute countdown timer will display on the
control to show when five minutes has elapsed.
After the five minutes has elapsed, proceed to the
next step.
Figure 65
Step 9
With an empty pail beneath the door spouts, raise
the prime plug.
Step 10
When a steady stream of sanitizing solution is
flowing from the prime plug opening in the bottom of
the freezer door, open the draw valve. Momentarily
open the center draw valve to sanitize the center
door spout. Draw off the remaining sanitizing
solution.
Model C723
. This will cause the
Step 11
Once the sanitizer stops flowing from the door
spout, touch the WASH symbol
draw valve.
Note: Be sure your hands are clean and
sanitized before proceeding to the next step.
Step 12
Lubricate the feed tube o-rings on the end with the
small hole on the side. Stand the feed tube in the
corner of the hopper.
Step 13
Factory equipped agitator units only: Place the
agitator on the agitator drive shaft housing.
Note: If the agitator should stop turning during
normal operation, with sanitized hands, remove
agitator from agitator drive shaft housing and brush
clean with sanitizing solution. Install the agitator
back onto the agitator drive shaft housing.
Step 14
Repeat these steps for the other side of the
machine.
33
and close the
Figure 66
Operating Procedures