Taylor C723 Operator's Manual page 28

Program the AUTO START TIME by selecting the
UP arrow symbol to move the arrow to "Change."
Touch the SEL symbol to advance to the next
screen. (See Figure 32.)
AUTO START TIME
00:00
Figure 32
Use the arrow symbols to program the AUTO
START TIME by increasing or decreasing the hour
setting above the cursor. Touch the SEL symbol to
advance the cursor and program the minutes
setting. Select the SEL symbol to return to the
previous screen with the new time setting displayed.
Select the SEL symbol to exit the screen and return
to the Manager's Menu.
The STANDBY option is used to manually place
either side of the machine in the Standby mode
during long, no draw periods. Select the STANDBY
screen from the Menu. Touch the SEL symbol to
activate Standby.
Discontinue Standby operation by exiting the
Manager's Menu and selecting the AUTO mode.
(See Figure 33.)
STANDBY MODE
LEFT
RIGHT
> Exit
Figure 33
The MIX LEVEL AUDIBLE option, when enabled,
will alert the operator with an audible tone when
there is a mix low or mix out condition. The following
screen is displayed upon selecting this option.
(See Figure 34.)
MIX LEVEL AUDIBLE
ENABLED
> Enable
Disable
Figure 34
Disable the audible tone feature by selecting the UP
arrow symbol to move the arrow to "Disable." Select
Important: To the Operator
the SEL symbol to save the new setting and return
to the Manager's Menu. The control panel icons for
Mix Low and Mix Out will light as the mix level drops
in the hopper but the audible tone will be disabled.
The FAULT DESCRIPTION screen lists any faults
detected by the control and allows the Manager to
clear them from the system. Faults are displayed on
the second and/or third line. (See Figure 35.)
FAULT DESCRIPTION
L: Beater Overload
R: Beater Overload
Pressing the SEL symbol displays the next fault or
returns to the Manager's Menu if no other faults
exist. Pressing the SEL symbol any time faults are
displayed will clear corrected faults upon returning to
the Manager's Menu. Press the Menu symbol to
return to the Manager's Menu.
The FAULT HISTORY screen displays a history of
the last 100 faults. Page numbers are displayed in
the upper right-hand corner. Page 1 contains the
most recent fault. Use the arrow symbols to cycle
through the history pages. The date and time of the
event are displayed on the second line. The third
line displays the reason for the fault.
(See Figure 36.)
FAULT HISTORY
02/27/11
HPCO COMPRESSOR
> Exit
The LOCKOUT HISTORY screen displays a history
of the last 100 hardlocks, brush clean dates, etc.
(See Figure 37.)
LOCKOUT HISTORY
02/27/11
< HPR THERM FAIL
> Exit
24
Figure 35
12:58
Figure 36
12:58
Figure 37
Model C723
1