2.12 Sending Alarm Log Information
You can configure the camera to send a daily log by E-mail that reports the status of the built-in sensor, external
sensor, and detection triggers. This allows you to be notified by E-mail once a day and know whether or not
there were any events that triggered the camera. Ask your Internet Service Provider (ISP) or network
administrator for the appropriate settings.
1.
Click the [Setup] tab.
2.
On the left side of the screen under [Buffer/Transfer], click [Alarm Log].
3.
Set the following parameters as desired.
a.
Under [A setup of operation], select the desired setting.
–
[Never send alarm logs]: Alarm logs will not be sent.
–
[Always send alarm logs]: Alarm logs will be sent, even if the camera was not triggered.
–
[Send alarm logs only when the camera was triggered]: Alarm logs will be sent if the camera was
triggered.
–
[Send alarm logs only when the camera was not triggered]: Alarm logs will be sent only if the camera
was not triggered.
2.12 Sending Alarm Log Information
Operating Instructions
87