Panasonic BL-C210 Series Operating Instructions Manual page 117

•
If the camera is connected to a router, you can usually leave this field blank.
d.
Under [Default Gateway], enter the default gateway IP address if required by your ISP or network
administrator.
•
This field can normally be left empty.
e.
Under [DNS], enter the IP addresses of the primary and secondary DNS servers if required by your
ISP or network administrator.
•
These fields can normally be left empty.
f.
Under [Max. Bandwidth Usage], select the maximum bandwidth you want to allow the camera to use.
•
This setting is effective for both IPv4 and IPv6 connections.
•
Refer to the following file size information when restricting the maximum bandwidth. Note that these
are estimated file sizes for one JPEG image (the actual file size may vary depending on image
quality, image brightness, etc.). To determine the bandwidth required, multiply this number by the
number of accesses (for JPEG images), and multiply the H.264 or MPEG-4 bit rate setting on the
[Video Streaming] page by the number of H.264 or MPEG-4 accesses.
– 192 ´ 144: 7 KB (56 Kbit)
– 320 ´ 240: 16 KB (128 Kbit)
– 640 ´ 480: 35 KB (280 Kbit)
g.
Under [Connection Type], select the appropriate connection type.
•
Normally you can leave this setting at [Auto Negotiation].
•
This setting is effective for both IPv4 and IPv6 connections.
2.
Click [Save].
3.
When the [New settings are saved.] message is displayed, click [Restart].
•
All images buffered in the internal memory are deleted when the camera is restarted.
[Space], ["], ['], [&], [<], and [>] cannot be entered.
*1
Note
•
If the camera's IP address was changed as a result of changing the network settings, use the Setup
Program on the CD-ROM to find the camera's new IP address (see Page 202).
•
The current network settings can be confirmed on the [Status] page (see Page 176).
5.1.1 Network (IPv4) Settings
Operating Instructions 117