When the precise pan/tilt feature is turned on (click [On] under [Precise] in the operation bar), the navigation
buttons move the camera in small increments, allowing precise lens control.
•
The camera lens moves to the home position when it is turned on. You can change the home position if
necessary (see Page 29).
This feature can be disabled for general users (see Page 152) and for guest users (see Page 155).
Presets
Allow you to move the lens to a pre-programmed position. You can register up to 8 presets (see Page 29).
Click buttons 1–8 to move the lens to the corresponding preset, or select the desired preset from the pull-down
menu. You can also move the lens to the home position by clicking the center navigation button.
This feature can be disabled for general users (see Page 152) and for guest users (see Page 155).
Note
•
If the camera is aimed at a preset position while zoomed, the position may vary slightly from the
registered preset position.
1.2.2 Aiming the Camera Lens
Operating Instructions
27