Restarting The Camera In Wireless Mode (Bl-C230 Only) - Panasonic BL-C210 Series Operating Instructions Manual

5.3.2 Restarting the Camera in Wireless Mode (BL-C230 Only)

5.3.2 Restarting the Camera in Wireless Mode (BL-C230 Only)
After you have configured the camera for wireless connection, follow the procedure below to restart the camera
in wireless mode.
1.
Turn off the camera by unplugging the AC plug from the power outlet.
2.
Set the WIRELESS/WIRED switch on the bottom of the camera to the WIRELESS position.
3.
Turn the camera on by plugging the AC plug into the power outlet.
4.
Confirm the camera's wireless settings are correct by accessing the camera (see Page 8).
Note
•
To use the camera in wired mode again, repeat the procedure above and set the WIRELESS/
WIRED switch on the bottom of the camera to the WIRED position.
•
If you cannot access the camera, the camera's wireless settings may be incorrect. Repeat the
procedure above and set the WIRELESS/WIRED switch on the bottom of the camera to the WIRED
position. Access the camera in wired mode and confirm that all wireless settings are correct and match
the settings of your wireless router.
•
If your wireless router uses MAC address filtering, enter the MAC address of the camera and the MAC
address of the camera's wireless module when setting your wireless router's MAC address filtering
feature. You can confirm the camera's MAC address on the [Status] page (see Page 176) and the
MAC address of the wireless module on the [Wireless Status] page (see Page 177).
•
You may need to restart your router in order to access the camera in wireless mode.
•
Even if the camera is turned on in wired mode, it emits radio waves for about 5 minutes. During this
time, the router's wireless indicator may light or flash.
•
If you still cannot access the camera in wireless mode, see 1.4 Wireless Connection Issues (BL-C230
Only) in the Troubleshooting Guide.
138 Operating Instructions