Table of Contents
Advertisement
Introduction
This product is an additional product designed to be used with the following Panasonic Video Intercom Systems.
– VL-SWD501BX/VL-SWD501UBX (Main monitor station: VL-MWD501BX)
(The corresponding models are subject to change without notice.)
You must register this product with your Video Intercom System before it can be used.
R For registration information, refer to the Installation Guide of this product or the Operating Instructions of the Video
Intercom System.
R This manual only covers the information and cautions required for the preparation and initial use of the product.
For detailed information on how to operate the product, refer to the Operating Instructions of the Video Intercom
System.
R The illustrations in the supplied manual(s) may vary slightly from the actual product.
R See the Installation Guide for information about accessories.
Product names used in this manual
Model No.
*1
VL-WD812BX
VL-MWD501BX
VL-WD613BX
*1 The product label reads as follows: VL-WD812EX
General information
R In the event of problems, you should contact your equipment supplier in the first instance.
For your future reference
We recommend keeping a record of the following information to assist with any repair under warranty.
Serial No.
(found on the rear of the product)
Name and address of dealer
Attach your purchase receipt here.
For your safety
To prevent severe injury and loss of life/property, read
this section carefully before using the product to ensure
proper and safe operation of your product.
WARNING
Preventing fire, electric shock and short circuits
R Use only the power source marked on the product. If
you are not sure of the type of power supplied to your
home, consult your dealer or local power company.
R Use only the specified power supply unit and AC
cable.
2
Product name
Wireless sensor camera
Main monitor station
Wireless monitor station
Camera
Main monitor
Sub monitor
Date of purchase
R Do not attempt to disassemble or modify this product.
Contact an authorised service centre for repairs.
R Never touch the power supply unit and AC cable with
wet hands.
R Do not touch the power supply unit and AC cable
during an electrical storm.
R Never spill liquids on the power supply unit and AC
cable (the power supply unit and AC cable are for
indoor use only). Do not directly spray the camera
with water from a hose or other objects. Never spill
any liquid inside the product.
If the power supply unit, AC cable, or internal parts of
the camera become wet, unplug the product and
contact an authorised service centre.
R Never put metal objects inside the product. If metal
objects enter the product, unplug the product and
contact an authorised service centre.
Name in this manual
Advertisement
Table of Contents
