Panasonic BL-C210 Series Operating Instructions Manual page 89

–
[POP before SMTP authentication]: Select this option if the outgoing E-mail server requires POP before
SMTP authentication when sending E-mail messages. The following settings are also necessary. Enter
the settings as you would for receiving E-mail.
a.
Enter the IP address or the host name
•
An IPv6 address can be specified; note that the IPv6 address must be enclosed in brackets.
b.
Enter the port number used by the server. (Port 110 is normally used for POP3.)
c.
Enter the login ID
d.
Enter the password
–
[SMTP authentication]: Select this option if the outgoing E-mail server requires SMTP authentication
when sending E-mail messages. The following settings are also necessary. Enter the settings as you
would for sending E-mail.
a.
Enter the login ID
b.
Enter the password
•
The camera supports LOGIN, PLAIN, and CRAM-MD5 authentication.
5.
Under [SSL], select [Use] if you want to use SSL encryption when sending E-mail.
•
When [Use] is selected, the port number under [E-mail Transfer] may need to be set to 465. Ask your
ISP or network administrator for the appropriate settings.
•
SSL supports SMTP over SSL. STARTTLS is not supported.
6.
Click [Save], then click [Go to Alarm Log page].
Note
•
When the settings are saved, the number of new alarm logs becomes 0.
*1 [Space], ["], ['], [&], [<], and [>] cannot be entered.
*2 ["] cannot be entered.
*1
(user name) required to access the server (max. 63 characters).
*2
required to access the server (max. 63 characters).
*2
(user name) required to access the server (max. 63 characters).
*2
required to access the server (max. 63 characters).
*2
2.12 Sending Alarm Log Information
of the POP3 server (incoming mail server).
Operating Instructions 89