Panasonic BL-C210 Series Operating Instructions Manual page 102

4.1 Configuring Port Forwarding
Enabling [Auto Port Forwarding] using the [UPnP] page
1.
Click the [Setup] tab.
2.
On the left side of the screen under [Basic], click [UPnP].
3.
Under [Auto Port Forwarding], select [Enable].
4.
Click [Save].
•
When setup is complete, [Success!] is displayed.
5.
Confirm that port forwarding was configured correctly (see Page 102).
Note
•
If auto port forwarding is enabled or disabled on this page, it is also enabled or disabled on the
[Internet] tab.
•
Screen content varies by model number.
Confirming that UPnP™ port forwarding is configured correctly
To confirm that the UPnP™ port forwarding has been successfully configured, follow the procedure below.
1.
Click the [Maintenance] tab.
2.
On the left side of the screen, click [Status].
3.
Under [UPnP], confirm that the status is [Enabled].
•
If [Enabled] is not displayed, refer to the UPnP™ related items in 1.3 Camera Setup Issues and
1.5 Camera Access Issues in the Troubleshooting Guide.
Configuring port forwarding without using UPnP™
If your router does not support UPnP™, you need to configure the router's port forwarding feature manually.
1.
Click the [Setup] tab.
2.
On the left side of the screen under [Basic], click [Network (IPv4)].
3.
Under [Connection Mode], click [Static].
4.
Make a note of the IP address and port number displayed here. You will need to know these settings when
configuring the router for port forwarding.
5.
Click [Save].
6.
Click [Restart].
102 Operating Instructions