Panasonic BL-C210 Series Operating Instructions Manual page 161

3.
Set the following parameters as desired.
a.
Under [Camera Name], change the camera name as desired (max. 15 characters).
•
See Page 206 for a list of valid characters. Note that [Space], ["], ['], [&], [<], and [>] cannot be
entered.
b.
Under [Single Camera], select the desired default refresh rate, image resolution, and image quality (for
when viewing MJPEG or still images) and streaming method (for when viewing H.264 or MPEG-4
images).
c.
Under [Multi-Camera], select the desired default refresh rate, image resolution, and image quality (for
when viewing MJPEG or still images).
d.
Under [Mobile Phone], select the desired default image resolution for when viewing still images with
your mobile phone.
e.
Under [Overlay Setting], select what information is displayed in the overlay displayed on the single
camera page, multi camera page, and buffered images page. See Page 11 for an example of a camera
image overlays. Screen content varies by model number.
i.
Select whether you want to display a time stamp in the upper left corner of camera images, then
select the desired format for the time stamp. To select 12-hour or 24-hour time format, see
Page 140.
ii.
Select whether you want to display a text message in the lower left corner of camera images, then
enter the desired text (max. 20 characters).
•
See Page 206 for a list of valid characters. Note that ["], ['], [&], [<], and [>] are not available.
iii.
Select whether you want to display status in the upper right corner of camera images.
•
[O] will be displayed when the sound detection feature has been triggered.
•
[M] will be displayed when the motion detection feature has been triggered.
•
[S] will be displayed when the built-in sensor has been triggered.
•
[1] or [2] will be displayed when external sensor 1 or 2, respectively, has been triggered.
•
will be displayed while the backlight correction feature is on.
Note
• When viewing images at 192 ´ 144 pixel resolution, status overlay is not displayed.
•
If the external sensor uses a ground to open signal (i.e., if you select [Rising: GND to Open
(High).] when configuring the alarm trigger), the corresponding alarm number is displayed
when the sensor is not being triggered. While the sensor is being triggered, the alarm
number disappears from the overlay.
f.
Under [Language], select the camera's display language.
•
The user can change the display language on the top page if desired.
•
If you select [Korean], Korean is displayed as the initial language when clicking the [Top], [Single],
[Multi], and [Buffered Image] tabs. All other pages are displayed in English.
g.
Under [Banner Display], select the desired parameters for the banner displayed on the single camera
page.
i.
Select whether you want to display a banner.
ii.
Select which users the banner is displayed for.
iii.
Enter the URL (max. 127 characters
This specifies the location of the image file that is displayed as the banner. Note that the file
extension of the image file must be .jpg or .png.
Note
•
If authentication is required to display the image URL, an authentication window will be
displayed when you access the single camera page.
•
Each time the single camera page is accessed, the camera accesses the URL of the banner
image file and reads the file. Be aware that the computer/server that contains the banner
image file may become burdened if the single camera page is accessed or refreshed
frequently.
), including http:// if necessary, of the banner image file.
*1
7.1 Changing Image Display Settings
Operating Instructions 161