Danfoss VLT AQUA Drive FC 202 Design Manual page 124

Type code and Selection
Description
Line power
option
Adaptation
6 6
Adaptation
Software
release
Software
language
Table 6.1 Ordering Type Code
1) Some of the available choices depend on the enclosure size.
2) Only available for adjustable frequency drives
3) Only available for adjustable frequency drives
Description
A options
B options
C0 options
C1 options
122
VLT
Position 1)
Possible choices
21 X: No line power option
1: Line power disconnect
3: Line power disconnect and fuse
5: Line power disconnect, fuse
and load sharing
7: Fuse
8: Line power disconnect and load
sharing
A: Fuse and load sharing
D: Load sharing
22 X: Standard cable entries
O: European metric thread in
cable entries
S: Imperial cable entries
23 X: No adaptation
24- SXXX: Latest release – standard
27 software
28 X: Not used
≥ 75 kW (100 hp).
≥ 355 kW (475 hp).
Position Possible choices
29- AX: No A option
30 A0: MCA 101 PROFIBUS DP V1
(standard)
A4: MCA 104 DeviceNet
(standard)
AN: MCA 121 Ethernet IP
AL: MCA 120 ProfiNet
AQ: MCA 122 Modbus TCP
31- BX: No option
32 BY: MCO 101 extended cascade
control
BK: MCB 101 general purpose
I/O option
BP: MCB 105 relay option
B0: MCB 109 I/O option with RTC
backup
B2: MCB 112 PTC thermistor card
B4: MCB 114 VLT sensor input
33- CX: No option
34
35 X: No option
R: MCB 113 Ext. relay card
5: MCO 102 Advanced cascade
control
Danfoss A/S © 09/2014 All rights reserved.
®
AQUA Drive FC 202
Description
C option
software
D options
Table 6.2 Ordering Type Code, Options
NOTICE!
For power sizes over 90 kW (125 hp), see the VLT
Drive FC 202 110–1400 kW Design Guide.
Position Possible choices
36- XX: Standard controller
37
38- DX: No option
39 D0: Extended 24 V DC backup
®
AQUA
MG20N622