List Of Jumpers And Dip-Switch - gefran SIEIDrive AVy Series Quick Start Up Manual

1.6. LIST OF JUMPERS AND DIP-SWITCH

Designation
S5 - S6 Terminating resistor for the serial interface RS485
ON= Termination resistor IN
OFF= No termination resistor
S8 Adaptation to the input signal of analog input 1 (terminals 1 and 2)
ON=0...20 mA / 4...20 mA
OFF=0...10 V / -10...+10 V
S9 Adaptation to the input signal of analog input 2 (terminals 3 and 4)
ON=0...20 mA / 4...20 mA
OFF=0...10 V / -10...+10 V
Adaptation to the input signal of analog input 3 (terminals 5 and 6)
S10
ON=0...20 mA / 4...20 mA
OFF=0...10 V / -10...+10 V
S11 - S12 - S13 Encoder setting ( jumpers on kit EAM_1618 supplied with the drive)
S14 - S15 - S16 ON=Sinusoidal SE
OFF=Digital DE
S17 Monitoring of the C-channel of the digital encoder
ON=C-Channel monitored
OFF=C-Channel not monitored (required for single-ended channels)
S18 - S19 Encoder setting
S20 - S21 Pos. B= reserved
Pos. A= reserved
S22 - S23 Analog input 3 enabling (alternative with SESC encoder)
Pos. A= reserved
Pos. B=analog input 3 enabled
Pos. OFF= resolver
S26 - S27 Reserved
S28 Encoder Internal power supply selection
ON / ON = +5 V
OFF / OFF = +8 V
S29 Internal use
S30 Second encoder qualifier input
A=from EXP-... board
B=from digital input "3" on RV33-4
S34 Jumper to disconnect 0V (+24V power supply) from ground
ON = 0V connected to ground
OFF = 0V disconnected from ground
S35 Jumper to disconnect 0V (regulation board) from ground
ON = 0V connected to ground
OFF = 0V disconnected from ground
S36 Internal use
S37 Internal use
S38-S39 Internal use
S40-S41 Power supply for the serial interface RS485
ON = Internal power supply (from pins XS.5 / XS.9)
(**)
OFF = External power supply (to pins XS.5 / XS.9)
(*) on multidrop connection the jumper must be ON only for the last drop of a serial line
see chapter 5.4
(**)
Function
—————— Quick Start up ——————
Factory setting
ON (*)
OFF
OFF
OFF
OFF
OFF
B
B
ON
ON/ON
A
A
ON
(hard-wire)
ON
(hard-wire)
not mounted
not mounted
ON
OFF
Ay4060
QS
19