Table of Contents
Advertisement
4. HANDLING
4.
HANDLING
This section explains the handling (installation preparations)
and nomencla-
ture of the AlSD71.
4.1
Handilng instructions
Since the body case is made of plastic, protect the A I SD71 from dropping
and sudden impacts.
Keep conductive debris out of the unit.
Turn the PC CPU power supply OFF before installing or removing the unit
to or from the base.
Turn the PC CPU and drive module power supply OFF before connecting
or disconnecting the drive unit connector.
After confirming the correct insertion direction, insert the connector
directly from the front. Then, tighten the two fixing screws.
When the drive unit is not connected, keep the connector area cover
closed.
When the AlSD71 is not BUSY, connect a peripheral device or AD71TU
to the A1 SD71.
After confirming the correct insertion direction, insert the connector
directly from the front. Then, tighten the two fixing screws.
When a peripheral device or AD71TU is not connected, keep the connec-
tor
area cover closed.
To install the module to a base unit, first put the module mounting hook
in the module mounting hole, and then tighten the two module mounting
screws to secure the module.
To remove the module, loosen and remove the two module mounting
screws first, and then disengage the module mounting hook from the
module mounting hole.
Module connector
Module mounting screws
I
Mod& mounting hook
Module mounting hole
4 - 1
Advertisement
Table of Contents
