T4 (D4 Output Timeout); T5 (D5 Output Timeout); T6 (D6 Output Timeout); T7 (D7 Output Timeout) - Digi XBee SX 868 User Manual

AT commands
Specifies how long pin D3 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

T4 (D4 Output Timeout)

This command applies to the XBee SX 868 RF Module.
Specifies how long pin D4 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

T5 (D5 Output Timeout)

This command applies to the XBee SX 868 RF Module.
Specifies how long pin D5 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

T6 (D6 Output Timeout)

This command applies to the XBee SX 868 RF Module.
Specifies how long pin D6 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

T7 (D7 Output Timeout)

This command applies to the XBee SX 868 RF Module.
XBee® SX 868 RF Module User Guide
I/O line passing commands
149