T6 (D6 Output Timeout); T7 (D7 Output Timeout); P0 (Pwm0 Configuration) - Digi XBee User Manual

AT commands
Note Minimum firmware version required: 1.xA0. Firmware versions are numbered in hexadecimal
notation.
Parameter range
0 - 0xFF (x 100 ms)
Default
0xFF

T6 (D6 Output Timeout)

Sets or displays output timeout values for lines that correspond with the D6 parameter. When the
output is set (due to I/O line passing) to a non-default level, a timer starts that sets the output to its
default level when it expires. The timer resets when a valid I/O packet is received.
The Tn parameter defines the permissible amount of time to stay in a non-default (active) state. If Tn
= 0, Output Timeout is disabled (output levels are held indefinitely).
Note Minimum firmware version required: 1.xA0. Firmware versions are numbered in hexadecimal
notation.
Parameter range
0 - 0xFF (x 100 ms)
Default
0xFF

T7 (D7 Output Timeout)

Sets or displays output timeout values for lines that correspond with the D7 parameter. When the
output is set (due to I/O line passing) to a non-default level, a timer starts that sets the output to its
default level when it expires. The timer resets when a valid I/O packet is received.
The Tn parameter defines the permissible amount of time to stay in a non-default (active) state. If Tn
= 0, Output Timeout is disabled (output levels are held indefinitely).
Note Minimum firmware version required: 1.xA0. Firmware versions are numbered in hexadecimal
notation.
Parameter range
0 - 0xFF (x 100 ms)
Default
0xFF

P0 (PWM0 Configuration)

Sets or displays the PWM0 configuration ().
This command enables the option of translating incoming data to a PWM so that the output can be
translated back into analog form.
XBee/XBee-PRO S1 802.15.4 (Legacy) User Guide
I/O settings commands
78