N? (Network Discovery Timeout); Security Commands; Ee (Security Enable); Ky (Aes Encryption Key) - Digi XBee 868LP User Manual

AT commands

N? (Network Discovery Timeout)

The maximum response time, in milliseconds, for ND (Network Discovery) responses and DN (Discover
Node) responses. The timeout is based on the NT (Network Discovery Back-off Time) and the network
propagation time.
Parameter range
[read-only]
Default
N/A

Security commands

The following AT commands are security commands.

EE (Security Enable)

Enables or disables 128-bit Advanced Encryption Standard (AES) encryption.
Set this command parameter the same on all devices in a network.
Parameter range
0 - 1
Parameter
0
1
Default
0

KY (AES Encryption Key)

Sets the 16-byte network security key value that the device uses for encryption and decryption.
This command is write-only. If you attempt to read KY, the device returns an OK status.
Set this command parameter the same on all devices in a network.
The value passes in as hex characters when you set it from AT command mode, and as binary bytes
when you set it in API mode.
Parameter range
128-bit value
Default
N/A
XBee 868LP RF Modules User Guide
Description
Disabled
Enabled
Security commands
139