Changing Parameters And Values - Swann AMU pH-Redox Operator's Manual

AMU pH-Redox
Operation
5.4.
Changing
parameters
Changing
values
A-96.250.441 / 060619

Changing Parameters and values

The following example shows how to change the logger interval:
Logger Sensors
Sensor type
Log interval
Disinf. Free chlorine
Clear logger
Temperature
Standards
Logger
Interval.
Log interval
Clear logger 5 min
10 min
30 min
1 Hour
Logger
Log interval
Clear logger
Logger
Log interval
Save ?
Clear logger
Yes
No
Alarm
Alarm High
Alarm Low -3.00 pH
Hysteresis
Delay
Alarm
Alarm High
Alarm Low -3.00 pH
Hysteresis
Delay
1 Select the parameter you want to
5.1.2 4.4.1
change.
FOME
30 min
2 Press [Enter]
no
NT5K
3 Press [
4.1.3
highlight the required parameter.
30min
4 Press [Enter] to confirm the selec-
no
tion or [Exit] to keep the previous
parameter).

The selected parameter is
4.1.3
highlighted but not saved yet.
10 min
5 Press [Exit].
no

Yes is highlighted.
4.1.3
6 Press [Enter] to save the new pa-
rameter.
no

The system reboots, the new
parameter is set.
1 Select the value you want to
5.3.1.1.1
change.
15.0 pH
2 Press [Enter].
0.10 pH
3 Set required value with [
5 Sec
[
4 Press [Enter] to confirm the new
5.3.1.1.1
value.
9.00 pH
5 Press [Exit].

Yes is highlighted.
0.10 pH
5 Sec
6 Press [Enter] to save the new val-
ue.
] or [ ] key to
] key.
] or
43