Swann AMU pH-Redox Operator's Manual page 31

AMU pH-Redox
Installation
A-96.250.441 / 060619
A Connector cap
B Connector
C Sensor
1 Carefully remove the protective cap [D] from the sensor tip.
Turn it clockwise only.
2 Rinse the sensor tip with clean water.
3 Insert the sensor through a hole in the flow cell block [E] into the
calibration vessel [F].
4 Tighten it hand-tight.
5 Remove the connector cap [A].
6 Screw the connector [B] onto the sensor.
7 Keep the protective caps on a secure place for later use.
8 Connect the sensor cable to the AMU transmitter according to
chapter Connect the Swansensor, p.
A
B
C
D
E
F
D Protective cap
E Flow cell block
F Calibration vessel
30.
29