Install Spray Nozzle (Option) Into M-Flow Cell - Swann AMU pH-Redox Operator's Manual

AMU pH-Redox
Installation
3.7.
A-96.250.441 / 060619

Install Spray Nozzle (Option) into M-Flow Cell

A B C
A Flow cell block bottom view
B Cleaning solution inlet
C Threaded hole for fixing screw
D Blind plug
To install the optional spray nozzle proceed as follows:
1 Stop operation according to chapter
tenance, p. 45.
2 Remove the sensors according to chapter 6, paragraph
move electrodes from flow cell, p.
3 Remove the calibration vessel [H] from the flow cell block [F]
and empty it.
4 Unscrew and remove the sealing screw form the cleaning solu-
tion inlet [B].
5 Insert the spray nozzle [G] so that its pin fits into the guiding slot
of the cleaning solution inlet.
6 To fix the spray nozzle screw the enclosed M4 screw into the
threaded hole [C] next to the cleaning solution inlet.
7 Fix the calibration vessel to the flow cell block.
8 Unscrew and remove the blind plug [D].
9 Install the hose nozzle [E].
10 Install the sensors.
D
E
H
E Hose nozzle
F Flow cell block
G Spray nozzle
H Calibration vessel
Stop of Operation for Main-
45.
F
open
close
G
Re-
31