Swann AMU pH-Redox Operator's Manual page 28

AMU pH-Redox
Installation
Install the
sensor
26
This instruction applies for both the pH and the ORP sensor.
A KCl bottle
B Connector cap
C KCl supply pipe
D Dosing tip
E Connector
1 Unscrew and remove the blind plug [F] from the flow cell block.
2 Carefully remove the protective cap [I] from the sensor tip. Turn
it clockwise only.
3 Rinse the sensor tip with clean water.
4 Insert the sensor through the flow cell block [H] into the calibra-
tion vessel [J].
5 Tighten it hand-tight.
6 Remove the connector cap [B].
7 Screw the connector [E] onto the sensor.
8 Keep the protective caps on a secure place for later use.
9 Attach the KCl supply pipe to the dosing tip of the KCl bottle.
10 Mount the KCl bottle to the bottle holder.
A
B
C
D
E
F
G
H
I
J
F Blind plug
G Sensor
H Flow cell block QV-Flow
I Protective cap
J Calibration vessel
A-96.250.441 / 060619