Changing Parameters And Values - Swann AMU Powercon Operator's Manual

AMU Powercon
Operation
4.4.
Changing
parameters
Changing
values
28

Changing Parameters and values

The following example shows how to set the Q-Flow sensor:
Sensors
Flow
Sensor parameters
Temp. Compensation
Quality Assurance
Sensors
Flow
Flow
None
Sensor parameters
Temp. Compensation Q-Flow
Quality Assurance
Sensors
Flow Q-Flow
Sensor parameters
Temp. Compensation
Quality Assurance
Sensors
Flow Q-Flow
Save ?
Sensor parameters
Yes
Temp. Compensation
No
Quality Assurance
Alarm Conductivity
Alarm High 300mS
Alarm Low 0.000
Hysteresis 1.00
Delay
Alarm Conductivity
Alarm High 120 mS
Alarm Low 0.000
Hysteresis 1.00
Delay
1 Select the parameter you want to
5.1.1
change.
None
2 Press <Enter>
3 Press [
5.1.1
highlight the required parameter.
None
4 Press <Enter> to confirm the se-
lection or <Exit> to keep the previ-
ous parameter).
 The selected parameter is
5.1.1
indicated (but not saved yet).
5 Press <Exit>.
 Yes is highlighted.
5.1.1
6 Press <Enter> to save the new pa-
rameter.
 The system reboots, the new
parameter is set.
1 Select the value you want to
5.3.1.1.1
change.
2 Press <Enter>.

S
 S
3 Set required value with [
5 Sec
[
4 Press <Enter> to confirm the new
5.3.1.1.1
value.
5 Press <Exit>.

S
  Yes is highlighted.
S
5 Sec
6 Press <Enter> to save the new
value.
] or [ ] key to
] key.
A-96.250.331 / 230320
] or