Swann AMU pH-Redox Operator's Manual page 84

AMU pH-Redox
Default Values
Signal Output 2
Alarm Relay:
pH mode
Redox mode
Relay 1and 2
pH mode
Redox mode
pH mode
Redox mode
82
Parameter: ....................................................................Temperature
Current loop: .....................................................................4 –20 mA
Function: .................................................................................. linear
Scaling: Range low: ...................................................................0 °C
Scaling: Range high:................................................................50 °C
Alarm:
Alarm high:......................................................................... 15.00 pH
Alarm low: ........................................................................... -3.00 pH
Hysteresis: ........................................................................... 0.10 pH
Alarm high:......................................................................... 1500 mV
Alarm low: .......................................................................... -500 mV
Hysteresis: ............................................................................. 10 mV
Delay:........................................................................................... 5 s
Sample Temp; Alarm high: .......................................................55 °C
Sample Temp; Alarm low: ..........................................................5 °C
Case temp. high:......................................................................65 °C
Case temp. low: .........................................................................0 °C
Function: .......................................................................... limit upper
Parameter: .................................................................... Meas. Value
Setpoint:............................................................................. 14.00 pH
Hysteresis: ........................................................................... 0.10 pH
Setpoint:............................................................................. 1500 mV
Hysteresis: ............................................................................. 10 mV
Delay:......................................................................................... 30 s
If Function = Control upw. or dnw:
Parameter: ................................................................... Meas. Value
Settings: Actuator: ...........................................................Frequency
Settings: Pulse Frequency: ............................................. 120/min
Settings: Control Parameters: Setpoint: ......................... 14.00 pH
Settings: Control Parameters: P-band:............................. 0.10 pH
Settings: Control Parameters: Setpoint: ......................... 1500 mV
Settings: Control Parameters: P-band:............................... 10 mV
Parameter: .................................................................. Temperature
Settings: Actuator: ...........................................................Frequency
Settings: Pulse Frequency: ............................................. 120/min
Settings: Control Parameters: Setpoint: ...............................50 °C
Settings: Control Parameters: P-band:...................................1 °C
Parameter: ...................................................................Sample flow
Settings: Actuator: ...........................................................Frequency
Settings: Pulse Frequency: ............................................. 120/min
Settings: Control Parameters: Setpoint: ........................... 25.0 l/h
Settings: Control Parameters: P-band:.................................. 1 l/h
A-96.250.441 / 060619