Changing Parameters And Values - Swann AMI Powercon Operator's Manual

AMI Powercon
Operation
5.4.
Changing
parameters
Changing
values
42

Changing Parameters and values

The following example shows how to set the Q-Flow sensor:
Sensors
Flow
Sensor parameters
Temp. Compensation
Quality Assurance
Sensors
Flow
Flow
None
Sensor parameters
Temp. Compensation
Q-Flow
Quality Assurance
Sensors
Flow
Sensor parameters
Temp. Compensation
Quality Assurance
Sensors
Flow
Save ?
Sensor parameters
Yes
Temp. Compensation
No
Quality Assurance
Alarm Conductivity
Alarm High
Alarm Low 0.000
Hysteresis 1.00
Delay
Alarm Conductivity
Alarm High 120 mS
Alarm Low 0.000
Hysteresis 1.00
Delay
1 Select the parameter you want to
5.1.1
change.
None
2 Press <Enter>
3 Press [
5.1.1
highlight the required parameter.
None
4 Press <Enter> to confirm the se-
lection or <Exit> to keep the previ-
ous parameter).

The selected parameter is
5.1.1
indicated (but not saved yet).
Q-Flow
5 Press <Exit>.

Yes is highlighted.
5.1.1
6 Press <Enter> to save the new pa-
Q-Flow
rameter.

The system reboots, the new
parameter is set.
1 Select the value you want to
5.3.1.1.1
change.
300mS
 2 Press <Enter>.
S

S
3 Set required value with [
5 Sec
[
4 Press <Enter> to confirm the new
5.3.1.1.1
value.
 5 Press <Exit>.
S


Yes is highlighted.
S
5 Sec
6 Press <Enter> to save the new val-
ue.
] or [ ] key to
] key.
A-96.250.341 / 061015
] or