Swann AMU pH-Redox Operator's Manual page 14

AMU pH-Redox
Product Description
Fluidics
M-Flow
12
The flow cell M-Flow 10-3PG consists of the flow cell block [C] and
the calibration vessel [D]. The pH sensor [A] and the temperature
sensor [B] are screwed into the flow cell block [C].
Optionally a spray nozzle [F] can be installed. The spray nozzle al-
lows the cleaning of the sensor tips without removing the sensors.
The sample enters at the sample inlet [H] and flows then through
the flow cell block into the calibration vessel [D], were pH and redox
are measured. The pH value depends on the sample temperature.
The measuring value of the temperature sensor [B] is used to recal-
culate the pH measuring value to a predefined average sample
temperature.
The sample leaves the calibration vessel via flow cell block through
the sample outlet [E] and flows into the pressure free drain [G].
A
C
D
H
F
A pH sensor
B Temperature sensor
C Flow cell block
D Calibration vessel
B
E
G
E Sample outlet
F Spray nozzle
G Drain
H Sample inlet
A-96.250.441 / 060619