Table of Contents
Advertisement
AMU pH-Redox
Program List and Explanations
5.3.2.6
5.3.2.7
5.3.2.24
5.3.2.341
5.3.2.44
5.3.2.54
5.3.2.6
5.3.2.7
5.3.2.24
5.3.2.342
5.3.2.342.1
76
Signal Outputs: Select operating mode of the signal output:
Cont.:
Signal outputs continue to issue the measured value.
Hold:
Signal outputs hold the last valid measured value.
Measurement is interrupted. Errors, except fatal errors,
are not issued.
Off:
Signal outputs are switched off (set to 0 or 4 mA).
Errors, except fatal errors, are not issued.
Output/Control: Select operating mode of the controller output:
Cont.:
Controller continues normally.
Hold:
Controller continues based on the last valid value.
Off:
Controller is switched off.
daily
The relay contact can be activated daily, at any time of a day.
Start time: to set the start time proceed as follows:
1 Press [Enter], to set the hours.
2 Set the hour with the [
3 Press [Enter], to set the minutes.
4 Set the minutes with the [
5 Press [Enter], to set the seconds.
6 Set the seconds with the [
Range: 00:00:00–23:59:59
Run Time: see Interval
Delay: see Interval
Signal Outputs: see Interval
Output/Control: see Interval
weekly
The relay contact can be activated at one or several days, of a
week. The daily starting time is valid for all days.
Calendar:
Start time: The programmed start time is valid for each of the pro-
grammed days. To set the start time see
] or [
] keys.
] or [
] keys.
] or [
] keys.
5.3.2.341, p.
A-96.250.441 / 060619
76.
Advertisement
Chapters
Table of Contents
