Ethernet Interface; Hardware, Interface - MICRO-EPSILON combiSensor KSH5 Instruction Manual

Ethernet Interface

combiSENSOR
6. Ethernet Interface
You will achieve especially high resolutions if you readout the measurements in digital form
via the Ethernet interface.
For that purpose, use the enclosed runtime version on CD-ROM, see 6.5, or use your own
program. Micro-Epsilon supports the MEDAQLib driver that includes all commands for the
controller KSS6380. You will find more details on the enclosed CD or on the Internet: www.
micro-epsilon.com/en/software "Standard applications > MEDAQlib".
6.1

Hardware, Interface

The data logging of all signals is synchronous.
Connect the controller to an available Ethernet interface at the PC. Use a crossover
cable.
For a connection with the controller you will require a defined IP address of the network
interface card inside the PC. Go to Control Panel\Network. Set up, if applicable, a new LAN
connection. For more information, contact you network administrator.
Fig. 9 LAN-Connection of a PC
Define the following address in the properties of the LAN connection:
IP address: 192.168.0.1
Subnet mask: 255.255.255.0
Select "Properties"
Page 41