Configuring The User Setup Menus - Cardiac Science Eclipse Premier Operating Instructions Manual

Chapter 4
System Setup and User Setup
Directory Password

Configuring the USER SETUP Menus

4-6
Eclipse Operating Instructions
ON
OFF
Determines whether a password is required to access the directory.
When ON, the user must enter the directory password after every
power up, when accessing the directory. The password is set in the
MISCELLANEOUS menu (see "Directory Password" on pg. 4-14)
NOTE: If the directory password is set to OFF in SYSTEM SETUP,
the directory password field will not appear in the MISCELLANEOUS
menu.
Verify calendar & clock settings
To verify the date and time, press the On/Standby key to put the unit in Standby mode.
Then press the On/Standby key again to turn the unit on.
Check the date and time on the POWER-UP screen.
There are 7 USER SETUP menus. Use these to format printouts and reports; customize
lead groups; customize demographic information in the EDIT ID menu and on
printouts; set default values for Recorder Speed, Gain and Frequency Response; get
Custom Header information; and configure miscellaneous settings.
All USER SETUP settings can be customized for both User 1 and User 2 (for more
information, see "User 1-2 Select" on pg. 4-2).
NOTE: Default settings for Eclipse Premier are given on page 9-2.
Go to the USER SETUP menus
1. Press the On/Standby key to power up to the PREVIEW screen.
2. Select the set of formats you want to edit by holding down the Shift
key and simultaneously pressing either the "1" key or "2" key (for
User 1 or User 2, respectively).
NOTE: The unit automatically turns off and on again whenever you
change the User selection.
3. Press the "M" key to go to the MAIN MENU.
4. In the MAIN MENU, select the desired USER SETUP menu by
pressing the appropriate "hot" key; for example, to select POWER-UP
DEFAULTS select the "O" key.
5. The new menu will appear (see Figure 4-2).
070-1149-01 B