Chrysler Concorde 2004 Service Manual page 1607

LH
CLOCK
DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . 1
OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
CLOCK
DESCRIPTION
Fig. 1 ANALOG CLOCK
1 - SET BUTTONS
2 - ANALOG CLOCK
The clock is of analog type (Fig. 1), mounted in the
instrument panel center air distribution bezel.
OPERATION
Refer to the Owner's Manual for setting instruc-
tions.
REMOVAL
(1) Open hood.
(2) Disconnect and isolate the negative battery
remote cable.
(3) Using a trim stick (special tool #C-4755), gently
pry out instrument panel air distribution outlet bezel
that retains the analog clock.
CLOCK
TABLE OF CONTENTS
page
REMOVAL
INSTALLATION
(4) Disconnect the one wire connector to the clock.
(5) Remove bezel from vehicle.
(6) On the bench, remove two retaining screws to
analog clock and remove from bezel (Fig. 2).
1 - WIRE HARNESS CONNECTOR
2 - CLOCK LAMP
3 - RETAINING SCREWS
INSTALLATION
(1) On the bench, place the clock into place on the
bezel and install the two retaining screws to analog
clock (Fig. 2).
(2) Connect the one wire connector to the clock.
(3) Place bezel into place and firmly snap into
place.
(4) Connect and isolate the negative battery
remote cable to the remote terminal.
(5) Close hood.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
. . . . . . . . . . . . . . . . . . . . . . . . . . 1
Fig. 2 ANALOG CLOCK REMOVAL
CLOCK 8C - 1
page