LH
TURN SIGNAL LAMP UNIT - CONCORDE/300M (Continued)
Fig. 63 FRONT PARKING, SIDE MARKER/TURN
SIGNAL LAMP UNIT
UNDERHOOD LAMP - POLICE
REMOVAL
(1) Open hood, disconnect and isolate the battery
negative remote terminal or pull fuse Y in the PDC.
(2) Insert a small flat blade in access slot between
the lamp base and lamp lens.
(3) Lift the lamp lens upward and remove the
lamp lens (Fig. 64).
(4) Depress bulb terminal inward (Fig. 65) to
release bulb.
Fig. 64 UNDERHOOD LAMP LENS
1 - LAMP
2 - LAMP LENS
LAMPS/LIGHTING - EXTERIOR 8L - 45
Fig. 65 UNDERHOOD LAMP
1 - BULB
2 - DEPRESS TERMINAL INWARD
3 - BULB WIRE LOOP
4 - LAMP BASE
INSTALLATION
(1) Engage the replacement bulb wire loop to ter-
minal closest to lamp base wire connector.
(2) Depress the opposite terminal inward and
engage the remaining bulb wire loop.
(3) Position the lamp lens on the lamp base and
press into place.
(4) Connect the battery negative remote cable or
reinsert fuse Y in the PDC.
(5) Verify system and vehicle operation.
UNDERHOOD LAMP UNIT -
POLICE
REMOVAL
(1) Open hood, disconnect and isolate the battery
negative remote terminal or pull fuse Y in the PDC.
(2) Disconnect the wire harness connector from
lamp unit.
(3) Remove the push-pin fastener attaching under-
hood lamp unit to inner hood panel (Fig. 66).
(4) Remove the underhood lamp unit from the
vehicle.