Diagnosis And Testing - Airbag System - Chrysler Concorde 2004 Service Manual

LH
RESTRAINTS (Continued)
Fig. 3 DRIVER AIRBAG LATERAL DEPLOYMENT
1 - SEATING REFERENCE
2 - DRIVER AIRBAG CUSHION LATERAL DEPLOYMENT ZONE
Fig. 4 PASSENGER AIRBAG DEPLOYMENT ZONE
1 - WINDSHIELD
2 - PASSENGER AIRBAG CUSHION
3 - 155 MM
4 - VERTICAL PLANE PASSING THROUGH THE MAXIMUM
REARWARD POINT THAT THE PASSENGER AIRBAG CUSHION
REACHES
5 - 600 MM
6 - VERTICAL PLANE TANGENT TO REARMOST PORTION OF
THE INSTRUMENT PANEL
7 - INSTRUMENT PANEL
ZONE
Fig. 5 PASSENGER AIRBAG LATERAL
DEPLOYMENT ZONE
1 - 333 MM
2 - CENTER OF PASSENGER AIRBAG
3 - PASSENGER AIRBAG DEPLOYMENT ZONE
4 - 217 MM
5 - REFERENCE POINT - TOP OF INTREPID LOGO

DIAGNOSIS AND TESTING - AIRBAG SYSTEM

(1) With the battery negative remote cable discon-
nected, connect the DRB III
Link connector.
(2) Turn the ignition key to the ON position. Exit
vehicle with the scan tool.
(3) After checking that no one is inside the vehicle,
connect the battery negative remote terminal.
(4) Read and record the ACTIVE Diagnostic Trou-
ble Code (DTC) data.
(5) Read and record any STORED DTC's.
(6) Refer to the proper Body Diagnostic Procedures
manual if any DTC's are found in Step 4 and Step 5.
(7) If the airbag warning lamp either fails to light,
or goes ON and stays ON, there is a system malfunc-
tion. To test the airbag warning lamp (bulb) opera-
tion in the cluster, refer to Electrical, Instrument
Cluster, Diagnosis and Testing - Instrument Cluster.
Refer to the proper Body Diagnostic Procedures man-
ual for any other system problems.
RESTRAINTS 8O - 5
scan tool to the Data