Installation - Chrysler Concorde 2004 Service Manual

8L - 42 LAMPS/LIGHTING - EXTERIOR
SPOT LAMP ASSEMBLY - POLICE (Continued)
(10) Loosen the clamp screw at the base of the
spot lamp head assembly (Fig. 55).
Fig. 55 SPOT LAMP HEAD ASSEMBLY
1 - SPOT LAMP HEAD CLAMP SCREW
(11) Carefully remove the spot lamp head with the
intermediate and inner shafts from the outer tube
and mounting bracket (Fig. 56).
Fig. 56 SPOT LAMP HEAD ASSEMBLY - REMOVE/
(12) Remove the screws retaining the spot lamp
mounting bracket to the A-pillar (Fig. 57).
(13) Remove the spot lamp outer tube and mount-
ing bracket from the A-pillar (Fig. 57).
INSTALL
Fig. 57 SPOT LAMP MOUNTING BRACKET -
REMOVE/INSTALL

INSTALLATION

CAUTION: Make sure that fuse F (master spot lamp
feed) or either fuse X or Y (left or right spot lamp
feed) are removed from the Power Distribution Cen-
ter (PDC) before performing service on the spot
lamps.
(1) Install the spot lamp outer tube and mounting
bracket to the A-pillar (Fig. 57).
(2) Install the screws retaining the spot lamp
mounting bracket to the A-pillar (Fig. 57) and tighten
to 33 N·m (29 in. lbs.).
(3) Carefully lift the edge of the secondary door
seal along the windshield pillar to expose the spot
lamp outer tube and apply a small amount of clear
silicone sealer to the base of the outer tube.
(4) Carefully install the spot lamp head with the
intermediate and inner shafts to the outer tube and
mounting bracket until the head assembly bottoms
out on the outer tube (Fig. 56).
(5) Tighten the clamp screw at the base of the spot
lamp head assembly in small incriments while test-
ing the effort required to rotate the spot lamp
between the stowed and operating positions. Stop
tightening the clamp screw when the spot lamp can
maintain any desired position (Fig. 55).
(6) Position the A-pillar trim to the spot lamp
outer tube.
CAUTION: Support the head of the spot lamp while
tightening the head assembly clamp screw. Main-
tain an operating or vertical position.
(7) Install the handle to the outer tube.
LH