Spot Lamp Assembly - Police Description; Operation; Diagnosis And Testing - Spot Lamp Assembly - Police - Chrysler Concorde 2004 Service Manual

8L - 40 LAMPS/LIGHTING - EXTERIOR
SPOT LAMP - POLICE (Continued)
(3) Connect the electrical connector to the spot
lamp head assembly.
(4) Tilt the sealed beam toward the spot lamp
head assembly.
(5) Install the bezel to the spot lamp head assem-
bly.
(6) Install the screws retaining the bezel to the
spot lamp head assembly (Fig. 49) and tighten to 2
N·m (18 in. lbs.).
(7) Lower the spot lamp from the operating to
stowed position.
(8) Install the fuse and PDC cover.
(9) Verify system and vehicle operation.
SPOT LAMP ASSEMBLY -
POLICE
DESCRIPTION
This vehicle may be equipped with up to two spot
lamp assemblies, attached to the A-Pillars (Fig. 50).
The spot lamp assembly switch is located on the han-
dle (Fig. 51), just above the rotating handle grip.
Fig. 50 SPOT LAMP ASSEMBLY LOCATION
Fig. 51 SPOT LAMP ASSEMBLY
Each spot lamp assembly contains a 100 watt halo-
gen bulb. The spot lamp assemblies are fused indi-
vidually and powered hot at all times. There are
three fuses in the Power Distribution Center (PDC)
that control the spot lamp assemblies:
• Fuse F - IP ACC3/SPOT LPS - 50 amp
• Fuse X - SPOT LP LT - 20 amp
• Fuse Y - SPOT LP RT/UNDERHOOD - 20 amp
The parts available for service are:
• Complete spot lamp assembly.
• H3 100 watt halogen bulb.
• Inside control handle w/switch.

OPERATION

Use this switch to turn the spot lamp assembly ON
and OFF. Rotate and twist the handle to adjust the
position of the spot lamp assembly (Fig. 52).
Fig. 52 SPOT LAMP ASSEMBLY OPERATION
1 - ON/OFF SWITCH
DIAGNOSIS AND TESTING - SPOT LAMP
ASSEMBLY - POLICE
IF SPOT LAMP DOES NOT LIGHT
(1) If both spot lamps are inoperative, check fuse F
(spot lamp master). Refer to Wiring Diagrams for
fuse locations. If fuses are OK, refer to Step 4. If
fuse(s) are faulty, replace as necessary.
(2) If the left spot lamp is inoperative, check fuse
X. If fuse is OK, refer to Step 4. If fuse is faulty,
replace as necessary. If fuse blows again, find short
to ground. Refer to Wiring Diagrams for circuit infor-
mation.
(3) If the right spot lamp is inoperative, check fuse
Y. If fuse is OK, refer to Step 4. If fuse is faulty,
replace as necessary. If fuse blows again, find short
to ground. Refer to Wiring Diagrams for circuit infor-
mation.
LH