Front Seat Belt & Retractor Removal - Chrysler Concorde 2004 Service Manual

8O - 14 RESTRAINTS
DRIVER AIRBAG TRIM COVER (Continued)
Fig. 17 DRIVER AIRBAG TRIM COVER HOUSING
CUT-AWAY
1 - LIP
2 - DRIVER AIRBAG TRIM COVER
3 - DRIVER AIRBAG HOUSING
4 - LOCKING BLOCK
(4) Install the trim cover retainer bracket to the
horn ground wire and place over the airbag housing
studs.
WARNING: BE CERTAIN THAT THE TABS ON THE
RETAINER ARE ENGAGED IN THE RETAINER
SLOTS OF THE TRIM COVER LOCKING BLOCKS
(Fig. 15).
(5) Install and tighten the nuts that secure the
trim cover retainers to the airbag housing studs.
Torque nuts to 10 N·m (90 in. lbs.).
For airbags with a blade style horn switch
feed wire:
(6) Route the horn switch feed wire between the
inflator housing and the upper airbag housing stud
(Fig. 13).
For airbags with connector style horn switch
feed wire:
(7) Install plastic wire retainer on the two side
studs (Fig. 14).
(8) Install the driver airbag onto the steering
wheel (Refer to 8 - ELECTRICAL/RESTRAINTS/
DRIVER AIRBAG - INSTALLATION).
FRONT SEAT BELT &
RETRACTOR
REMOVAL
WARNING: INSPECT THE CONDITION OF THE
SHOULDER/LAP BELT. REPLACE THE RETRACTOR
IF THE BELT IS CUT, FRAYED, TORN, OR DAM-
AGED IN ANY WAY.
(1) If necessary, move the front seat all the way
forward for access.
(2) Remove the turning loop adjuster knob.
(3) Detach the turning loop cover from the upper
anchor bolt.
(4) Remove the upper anchor bolt (Fig. 18).
Fig. 18 FRONT SEAT BELT RETRACTOR
1 - FRONT SEAT BELT RETRACTOR
2 - TURNING LOOP ADJUSTER
3 - B-PILLAR UPPER
4 - TURNING LOOP ADJUSTER KNOB
5 - UPPER SEAT BELT ANCHOR BOLT
6 - LOWER SEAT BELT ANCHOR BOLT
(5) Remove the B-pillar upper trim.
(6) Remove the lower anchor bolt.
(7) Remove the B-pillar lower trim panel.
(8) Disconnect the retractor wire harness connec-
tor (driver side only).
(9) Remove the retractor from the vehicle.
LH