Rear Seat Belt & Retractor - Center Removal; Installation - Chrysler Concorde 2004 Service Manual

LH
REAR SEAT BELT & RETRACTOR (Continued)
Fig. 23 REAR SEAT BELT RETRACTOR
1 - TURNING LOOP
2 - REAR SEAT BELT RETRACTOR
3 - SEAT BACK
4 - ANCHOR NUT
(2) Install the bolt to attach the seat belt retractor
to the quarter panel.
(3) Install the turning loop.
(4) Route the anchor end of the seat belt through
the upper quarter trim opening. Tighten to 40 N·m
(30 ft. lbs.).
(5) Install the nut to attach the lower seat belt
anchor to the floor. Tighten nut to 40 N·m (30 ft. lbs.)
torque.
(6) Install the lower quarter trim panel.
(7) Install the upper quarter trim panels.
(8) Install the seat back and cushion.
REAR SEAT BELT &
RETRACTOR - CENTER
REMOVAL
WARNING: INSPECT THE CONDITION OF THE
SHOULDER/LAP BELT. REPLACE THE RETRACTOR
IF THE BELT IS CUT, FRAYED, TORN, OR DAM-
AGED IN ANY WAY.
(1) Remove the rear shelf trim panel.
(2) Remove the bolt attaching the center rear seat
belt retractor to the rear shelf (Fig. 24).
(3) Remove the center rear seat belt retractor
assembly from the vehicle.
Fig. 24 REAR SEAT BELT RETRACTOR - CENTER
1 - CENTER REAR SEAT BELT RETRACTOR
2 - REAR SHELF
3 - REAR SPEAKER LOCATIONS

INSTALLATION

WARNING: INSPECT THE CONDITION OF THE
SHOULDER/LAP BELT. REPLACE THE RETRACTOR
IF THE BELT IS CUT, FRAYED, TORN, OR DAM-
AGED IN ANY WAY.
(1) Install the center rear seat belt retractor
assembly on the rear shelf. Torque the bolt to 40 N·m
(30 ft. lbs.).
(2) Install the rear shelf trim panel.
WARNING: THE REAR SEAT BACK RETAINING NUT
ALSO SERVES AS THE CENTER SEAT BELT
ANCHOR (Fig. 25). BE CERTAIN TO TORQUE THIS
NUT TO 40 N·m (30 ft. lbs.).
(3) Install the rear seat back. Be certain rear seat
belts are properly routed to avoid twisted or tangled
belts and/or buckles (Fig. 25).
RESTRAINTS 8O - 21