Removal; Installation - Chrysler Concorde 2004 Service Manual

LH
MULTI-FUNCTION SWITCH (Continued)
Fig. 40 TURN SIGNAL AND HAZARD SWITCH
CONNECTOR PIN CALL OUT
TURN SIGNAL AND HAZARD SWITCH
CONTINUITY
SWITCH POSITION
TURN HAZARD
SIGNAL WARNING
NEUTRAL
LEFT
RIGHT
NEUTRAL
CONTINUITY
OFF 1 AND 2
OFF 7 AND 6
OFF 7 AND 8
ON 2 AND 3
7 AND 8
7 AND 6
4 AND 5
LAMPS/LIGHTING - EXTERIOR 8L - 35
BEAM SELECT SWITCH CONTINUITY
Fig. 41 BEAM SELECT SWITCH CONNECTOR PIN
CALL OUT
SWITCH POSITION
LOW BEAM
HIGH BEAM
OPTICAL HORN

REMOVAL

(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Remove tilt lever.
(3) Remove both upper and lower steering column
shrouds. Refer to Body, Instrument Panel, Steering
Column Shrouds, Removal.
(4) Remove multi-function switch mounting screws
and connectors (Fig. 42).

INSTALLATION

(1) Install the multi-function switch connectors
and mounting screws (Fig. 42).
(2) Tighten multi-function switch retaining screws
to 17 in. lbs. (2 N·m) torque.
(3) Install both upper and lower steering column
shrouds. Refer to Body, Instrument Panel, Steering
Column Shrouds, Installation.
CONTINUITY
7 AND 5
7 AND 4
6 AND 4