Tail Lamp Unit Removal; Installation; Turn Signal Lamp Unit - Concorde/300M Removal - Chrysler Concorde 2004 Service Manual

8L - 44 LAMPS/LIGHTING - EXTERIOR
TAIL LAMP (Continued)
Fig. 60 TAIL LAMP - 300M
(6) Connect the battery negative cable and close
hood.
(7) Verify lamp operation.
TAIL LAMP UNIT
REMOVAL
(1) Release decklid latch and open decklid.
(2) Remove fasteners attaching trunk lining to
lower rear trunk panel.
(3) Move the trunk lining to access the tail lamp
unit fasteners.
(4) Remove nuts attaching tail lamp unit to lower
trunk and quarter panel (Fig. 61), (Fig. 62) and (Fig.
60).
(5) Remove tail lamp unit from vehicle.
(6) Disconnect tail lamp unit wire connector from
body wire harness.
Fig. 61 TAIL LAMP - CONCORDE
1 - PLASTIC HEX NUT (4)
2 - TAIL LAMP UNIT
Fig. 62 TAIL LAMP - INTREPID

INSTALLATION

(1) Connect tail lamp unit wire connector to body
wire harness.
(2) Place tail lamp unit in position on vehicle.
(3) Install nuts to attach tail lamp unit to lower
trunk and quarter panel.
(4) Place trunk lining in position on lower trunk
panel.
(5) Install fasteners to attach trunk lining to lower
rear trunk panel.
(6) Verify lamp operation.
TURN SIGNAL LAMP UNIT -
CONCORDE/300M
REMOVAL
(1) Open hood, disconnect and isolate the battery
negative cable.
(2) Remove headlamp unit to access lamp housing.
(3) Rotate and pull socket from lamp unit.
(4) Disconnect fastener attaching lamp unit to fas-
cia (Fig. 63).
(5) Remove lamp unit from vehicle.
INSTALLATION
(1) Place lamp unit in position on fascia.
(2) Install lamp unit fastener.
(3) Install bulb socket in lamp unit.
(4) Connect the battery negative cable.
(5) Verify lamp operation.
(6) Install headlamp unit.
(7) Close hood.
LH