Park/Turn Signal Lamp Removal; Installation - Chrysler Concorde 2004 Service Manual

8L - 36 LAMPS/LIGHTING - EXTERIOR
MULTI-FUNCTION SWITCH (Continued)
Fig. 42 MULTI-FUNCTION SWITCH
1 - MULTIFUNCTION SWITCH
2 - MOUNTING SCREW
3 - WIRING HARNESS
4 - STEERING COLUMN
5 - MOUNTING SCREW
(4) Install the tilt lever.
(5) Connect the negative battery cable remote ter-
minal to the remote battery post.
PARK/TURN SIGNAL LAMP
REMOVAL
INTREPID
(1) Open Hood, disconnect and isolate the battery
negative cable.
(2) Remove headlamp.
(3) Rotate and pull socket from lamp housing.
(4) Pull bulb from socket (Fig. 43).
300M
(1) Open Hood, disconnect and isolate the battery
negative cable.
(2) Reach under the fascia and remove the socket
from the lamp housing (Fig. 44).
(3) Rotate and pull socket from lamp housing.
(4) Pull bulb from socket.
CONCORDE
(1) Remove headlamp housing from vehicle.
(2) Disconnect wire connector from back of lamp
socket(s).
(3) Rotate socket and pull lamp socket from head-
lamp housing.
(4) Remove bulb from lamp socket.
Fig. 43 PARKING, SIDE MARKER, AND TURN
SIGNAL LAMP BULB - INTREPID
1 - LOW BEAM BULB
2 - PARK/TURN SIGNAL SOCKET
3 - HIGH BEAM BULB
Fig. 44 PARKING, SIDE MARKER, AND TURN
SIGNAL LAMP BULB - 300M
1 - BULB
2 - SOCKET

INSTALLATION

INTREPID
(1) Push bulb into socket (Fig. 43).
(2) Install the lamp socket into lamp housing.
(3) Install the lamp housing.
(4) Install the jack screws attaching headlamp to
crossmember.
(5) Connect the negative battery cable and close
hood.
LH