Chrysler Concorde 2004 Service Manual page 1594

8A - 6 AUDIO/VIDEO
ANTENNA - SATELLITE RADIO (Continued)
(5) From inside the vehicle, and using a flat
bladed tool, depress one of the retaining tabs on the
antenna. Push up the one side of the antenna con-
nector through the roof panel. Depress the other side
of the connector and remove the antenna.
(6) Remove any remaining adhesive with isopropyl
alcohol and a lint free cloth. If original antenna is
being reinstalled, remove adhesive from antenna
mounting surface.
INSTALLATION
(1) If original antenna is being installed, remove
backing from adhesive and apply to antenna base.
(2) Remove backing from the adhesive on the
antenna.
(3) Insert wire harness through hole in roof panel.
Press antenna into position until both retainers snap
into place.
(4) Connect wire harness connectors to antenna.
(5) Install headliner (Refer to 23 - BODY/INTERI-
OR/HEADLINER - INSTALLATION).
(6) Connect battery negative cable.
ANTENNA - NAVIGATION
RADIO
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the radio (Refer to 8 - ELECTRICAL/
AUDIO/RADIO - REMOVAL).
(3) Disconnect antenna from radio. Remove tape
securing antenna to air duct, and remove antenna.
INSTALLATION
(1) Secure antenna to air duct.
(2) Connect antenna to radio.
(3) Install radio (Refer to 8 - ELECTRICAL/AU-
DIO/RADIO - INSTALLATION).
(4) Connect battery negative cable.
ANTENNA CABLE - SATELLITE
RADIO
DESCRIPTION
The satellite radio antenna connects the roof
mounted antenna to the satellite receiver module. It
has two connectors at each end and is routed above
the headliner, then down the right side of the vehicle
floor below the carpet.
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Lower the rear portion of the headliner as nec-
essary to access the underside of the satellite
antenna (Refer to 23 - BODY/INTERIOR/HEAD-
LINER - REMOVAL).
(3) Remove the lower quarter trim panel (Refer to
23 - BODY/INTERIOR/LOWER QUARTER TRIM -
REMOVAL).
(4) Remove the front and rear door sill trim (Refer
to 23 - BODY/INTERIOR/DOOR SILL TRIM -
REMOVAL).
(5) Push carpet back to access body harness.
(6) Detach the antenna cable from the body har-
ness (Fig. 4). Disconnect wire harness connectors at
each end of the cable.
Fig. 4 ANTENNA CABLE - SATELLITE RADIO
1 - SATELLITE RECEIVER MODULE
2 - SATELLITE RADIO ANTENNA CABLE
INSTALLATION
(1) Secure the antenna cable to the body harness.
Connect the wire harness connectors at each end of
the antenna cable.
(2) Install the front and rear door sill trim (Refer
to 23 - BODY/INTERIOR/DOOR SILL TRIM -
INSTALLATION).
(3) Install the lower quarter trim (Refer to 23 -
BODY/INTERIOR/LOWER
INSTALLATION).
(4) Install the headliner (Refer to 23 - BODY/IN-
TERIOR/HEADLINER - INSTALLATION).
(5) Connect the battery negative cable.
LH
QUARTER TRIM -