Tips And Tricks - Danfoss VLT Aqua Drive FC 202 Operating Instructions Manual

6. How to operate the frequency converter

6.1.7. Tips and tricks

Table 6.1: Tips and tricks
6
6.1.8. Quick Transfer of Parameter Settings when using GLCP
Once the set-up of a frequency converter is complete, it is recommended to store (backup) the
parameter settings in the GLCP or on a PC via MCT 10 Set-up Software Tool.
Data storage in LCP:
1.
2.
3.
4.
All parameter settings are now stored in the GLCP indicated by the progress bar. When 100% is
reached, press [OK].
The GLCP can now be connected to another frequency converter and the parameter settings cop-
ied to this frequency converter.
Data transfer from LCP to Frequency converter:
1.
2.
3.
4.
The parameter settings stored in the GLCP are now transferred to the frequency converter indi-
cated by the progress bar. When 100% is reached, press [OK].
54
* For the majority of water and wastewater applications the Quick Menu, Quick
Setup and Function Setups provides the simplest and quickest access to all the
typical parameters required.
* Whenever possible, performing an AMA, will ensure best shaft performance
* Contrast of the display can be adjusted by pressing [Status] and [ ] for darker
display or by pressing [Status] and [ ] for brighter dispaly
* Under [Quick Menu] and [Changes Made] all parameters that have been changed
from factory settings are displayed
* Press and hold [Main Menu] key for 3 seconds for access to any parameter
* For service purposes it is recommended to copy all parameters to the LCP, see
par 0-50 for further information
NB!
Stop the motor before performing any of these operations.
LCP Copy
Go to par. 0-50
Press the [OK] key
Select "All to LCP"
Press the [OK] key
Go to par. 0-50 LCP Copy
Press the [OK] key
Select "All from LCP"
Press the [OK] key
MG.20.M2.02 - VLT
▼
®
is a registered Danfoss trademark
®
VLT AQUA Drive
Operating Instructions
▲