Danfoss VLT Aqua Drive FC 202 Operating Instructions Manual page 83

®
VLT AQUA Drive
Operating Instructions
7.1.7. Changing a Text Value
If the selected parameter is a text value,
change the text value by means of the up/
down navigation keys.
The up key increases the value, and the down
key decreases the value. Place the cursor on
the value to be saved and press [OK].
7.1.8. Changing a Group of Numeric Data Values
If the chosen parameter represents a numeric
data value, change the chosen data value by
means of the <> navigation keys as well as
the up/down navigation keys. Use the <>
navigation keys to move the cursor horizon-
tally.
Use the up/down navigation keys to change
the data value. The up key enlarges the data
value, and the down key reduces the data val-
ue. Place the cursor on the value to be saved
and press [OK].
7.1.9. Changing of Data Value,Step-by-Step
Certain parameters can be changed step by step or infinitely variably. This applies to
er
(par. 1-20),
The parameters are changed both as a group of numeric data values and as numeric data values
infinitely variably.
7.1.10. Read-out and Programming of Indexed Parameters
Parameters are indexed when placed in a rolling stack.
Par. 15-30 to 15-32 contain a fault log which can be read out. Choose a parameter, press [OK],
and use the up/down navigation keys to scroll through the value log.
Use par. 3-10 as another example:
Choose the parameter, press [OK], and use the up/down navigation keys keys to scroll through
the indexed values. To change the parameter value, select the indexed value and press [OK].
Change the value by using the up/down keys. Press [OK] to accept the new setting. Press [Cancel]
to abort. Press [Back] to leave the parameter.
Motor Voltage
(par. 1-22) and
®
MG.20.M2.02 - VLT is a registered Danfoss trademark
7. How to programme the frequency converter
Illustration 7.11: Display example.
Illustration 7.12: Display example.
Illustration 7.13: Display example.
Motor Frequency
(par. 1-23).
7
Motor Pow-
83