Siemens SINUMERIK 802D sl Function Manual page 275

PONS
Punching ON (in position control cycle)
PONS
PDELAYON
Punching with delay ON
PDELAYON
PON
The delay time in seconds is programmed in setting data:
SD42400 PUNCH_DWELLTIME
If the defined value cannot be divided as an integer into the interpolation clock cycle, then it
is rounded to the next divisible integer value.
The function has a modal action.
PDELAYOF
Punching with delay OFF
PDELAYOF
normally.
Programming example:
SPIF2
high-speed I/Os (see machine data MD26004 and MD26006).
:
N170 PDELAYON X100 SPOF
N180 X800 PON
N190 PDELAYOF X700
:
SPIF1
Activation of first punch interface
SPIF1
speed I/Os (see machine data MD26004 and MD26006).
The first punch interface is always active after a reset or control system power up. If only one
interface is used, then it need not be programmed.
Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
behaves in the same way as
is a preparatory function. This means that
. The punch stroke is output with a delay when the programmed end position is reached.
deactivates punching with delay function, i.e. the punching process continues
and
PDELAYON PDELAYOF
activates the second punch interface, i.e. the stroke is controlled via the second pair of
activates the first punch interface, i.e. the stroke is controlled via the first pair of high-
. For explanation, please refer to
PON
PDELAYON
form a G code group.
; position without punch initiation, activate
; delayed punch initiation
; activate punching. The punch stroke is output
; with a delay when the end position is reached.
; deactivate punching with delay, normal punch
; initiation ON. End of programmed motion
;
Punching and Nibbling (N4)
15.3 Activation and deactivation
.
SONS
is generally programmed before
275